Study on mechanical properties of nickel-plated layer and abrasive holding force of electroplated diamond wire saw

XIE Qian; GE Peiqi; MENG Jianfeng; BI Wenbo; MA Xiaobin; ZHENG Chuxi; GONG Yang

doi:10.13394/j.cnki.jgszz.2020.1.0008

Volume 40 Issue 1

Feb. 2020

Turn off MathJax

Article Contents

Article Navigation > Diamond & Abrasives Engineering > 2020 > 40(1): 50-55

XIE Qian, GE Peiqi, MENG Jianfeng, BI Wenbo, MA Xiaobin, ZHENG Chuxi, GONG Yang. Study on mechanical properties of nickel-plated layer and abrasive holding force of electroplated diamond wire saw[J]. Diamond & Abrasives Engineering, 2020, 40(1): 50-55. doi: 10.13394/j.cnki.jgszz.2020.1.0008

Citation:

XIE Qian, GE Peiqi, MENG Jianfeng, BI Wenbo, MA Xiaobin, ZHENG Chuxi, GONG Yang. Study on mechanical properties of nickel-plated layer and abrasive holding force of electroplated diamond wire saw[J]. Diamond & Abrasives Engineering, 2020, 40(1): 50-55. doi: 10.13394/j.cnki.jgszz.2020.1.0008

Citation:

XIE Qian, GE Peiqi, MENG Jianfeng, BI Wenbo, MA Xiaobin, ZHENG Chuxi, GONG Yang. Study on mechanical properties of nickel-plated layer and abrasive holding force of electroplated diamond wire saw[J]. Diamond & Abrasives Engineering, 2020, 40(1): 50-55. doi: 10.13394/j.cnki.jgszz.2020.1.0008

PDF( 1210 KB)

Study on mechanical properties of nickel-plated layer and abrasive holding force of electroplated diamond wire saw

doi: 10.13394/j.cnki.jgszz.2020.1.0008

1. School of Mechanical Engineering, Shandong University, Jinan 250061, China;
2. Key Laboratory of High-Efficiency and Clean Mechanical Manufacture at Shandong University, Ministry of Education, Jinan 250061, China;
3. Shantian Abrasive Materials Limited Company, Linyi 276700, Shandong, China

More Information

Rev Recd Date: 2020-02-10

Available Online: 2022-04-06

Abstract

Abstract

The mechanical properties of nickel coating on electroplated diamond wire saw are directly affected by electroplating process parameters, which are difficult to determine.Electroplating specimens were prepared according to the electroplating process of diamond wire saw.The mechanical properties of the specimens were tested by nanoindentation/scratch tester and X-ray diffractometer.The hardness, modulus of elasticity, residual stress of nickel-plated layer and the bonding strength between nickel-plated layer and wire saw matrix were obtained.The holding force of nickel plating on diamond abrasive particles was calculated.According to the mechanical parameters of nickel coating obtained from the test, the finite element model of abrasive holding force is established and simulated.The simplified calculation results are in good agreement with the simulation results.
- electroplated diamond wire saw,
- nickel plating layer,
- diamond abrasives,
- holding force